- Location
- Lafayette,LA
I have a 94 SN Superjet with the following mods Lightened flywheel, Milled head 175 psi, and a 12/17 Solas concord. Should I get a limited or Mod chamber? I am most likely going to get a MSD enhancer shortly after.
Super Jet What B Pipe should i get for my set up
- Thread starter donteatdirt
- Start date
raytherace
Canadian Brapp Dealer
- Location
- St-Ray Beach, QC
http://factorypipe.com/p_yamaha.php
if you read that, its write that mod pipe is better for ported engine. I think you will only loose a bit of high speed with a mod chamber on a almost stock setup. IMO go limited.
if you read that, its write that mod pipe is better for ported engine. I think you will only loose a bit of high speed with a mod chamber on a almost stock setup. IMO go limited.
chriselmore_1
high on resin
- Location
- san jose ca
Get the limited pipe.
Freakrider
X247
- Location
- Tampa Bay area
limited is slightly snappier low end, right off throttle and I mean slightly...the mod will rip better midrange up when carving sooooo it's up to you as to how you're going to ride...I switched to the limited.
- Location
- Lafayette,LA
thanks guys. I have one more question. I bought the ski used, I am the third owner, the guy I bought it from bought it from the original owner who had it set up as a race ski. I'm not 100% sure but I think it might of had some port work done? The ski rips in the mid to top with the stock exhaust. The guy I bought it from does't know if its been ported or not. Any way for an easy check other then pulling the motor apart?
chriselmore_1
high on resin
- Location
- san jose ca
You'll have to pull the head to check. Easiest way
Freakrider
X247
- Location
- Tampa Bay area
With an engine flexible scope light down spark plug hole but you would have to know what wider exhaust ports look like...If it's race ported, it's a different type of exhaust porting to look for.
- Location
- Lafayette,LA
okay, I have a bore light that has a flexible light, any pics or info on what to look for? I don't want to pull the head.
- Location
- Lafayette,LA
I have a buddy that has the same engine with no port work if i compare the two would I be able to see the difference?
Freakrider
X247
- Location
- Tampa Bay area
give it a try and report back how it goes...
- Location
- Lafayette,LA
k i'll take a look at it this weekend thanks guys
- Location
- Lafayette,LA
I'm looking for a taller port right?
Freakrider
X247
- Location
- Tampa Bay area
Ya sounds like yours might be race ported...but also check for wider exhaust ports.