WCF venting hood pics?

masterblaster

masterblaster

X-H2
anyone have some vent pictures of their WF hood,I have 2 large sea doo type vents in this one and the ski takes on way too much water when it flips over in the surf,they cant be any longer with this type setup? ive seen the smaller tubes a few times just cant remember how they were setup? I have dual vents through the pole also,need this setup to be pretty water tight upside down and still breath decent on the throttle
 
masterblaster

masterblaster

X-H2
cant find any pics on the WCF site either? where are you guys gettin that real tight corrugated tubing,and how many are necessary
 
#ZERO

#ZERO

Beach Bum
Location
Florida - U.S.A.
You can use swimming pool hose and it comes in a variety of different colors.

I believe most people are running two hoses under the hood.

It can be purchased at Home Depot or any pool supply store.

200841816138657.jpg
 
masterblaster

masterblaster

X-H2
was seeing some really nice flat edge looking corrugated hose on some skis in Daytona? whos selling this stuff? Are 2 of these smaller hoses good enough with dual pole breathers?
 
Speedfreak

Speedfreak

Location
So. IL
I posted a picture of mine in the thread "why aftermarket hoods suck" http://www.x-h2o.com/threads/38450

I can't find 3 inch shop vac hose all I can find is 2.5 inch. I am leaning towards the idea of using spray in foam to seal one side of the hood and then blocking the hose on the opposite side. So that water runs diagonal across the hood instead of straight in. I think the pole breathers should be fine. I have my tubes out and duct tape over the holes now so that I can try to run it with just the pole breather. I have a 2.5 inch pole breather.

XFT-Lou has flexible 3 inch hose he got from an auto parts store. It is used for engine dressup for jap cars. It pops in place like s kids straw so you can bend it and it will stay in place.

If you come up with an idea let me know.
 
Mark44

Mark44

Katie's Boss
Location
100% one place
p

Speedfreak said:
I posted a picture of mine in the thread "why aftermarket hoods suck" http://www.x-h2o.com/threads/38450

I can't find 3 inch shop vac hose all I can find is 2.5 inch. I am leaning towards the idea of using spray in foam to seal one side of the hood and then blocking the hose on the opposite side. So that water runs diagonal across the hood instead of straight in. I think the pole breathers should be fine. I have my tubes out and duct tape over the holes now so that I can try to run it with just the pole breather. I have a 2.5 inch pole breather.

XFT-Lou has flexible 3 inch hose he got from an auto parts store. It is used for engine dressup for jap cars. It pops in place like s kids straw so you can bend it and it will stay in place.

If you come up with an idea let me know.
Click to expand...

McMaster has every type and size hose you will ever need.

Mark44
 
You must log in or register to reply here.
Top Bottom