Tray heater works!!

ATS_Aaron

ATS_Aaron

X-
Location
Shady Shores, TX
I drilled and tapped my water outlet and attached a 1/8th NPT to 3/8 hose fitting to it. I then ran a length of 3/8th hose to dump the warm water straight down right at the front of the tray. It cascades down and runs out the back. Kept my feet toasty warm today in 60 degree water.

I read about the tip somewhere here, so whoever you are: THANKS!!

Aaron
 
Shonuff

Shonuff

I've got the glow
Site Supporter
Location
Memphis
ATS_Aaron said:
I drilled and tapped my water outlet and attached a 1/8th NPT to 3/8 hose fitting to it. I then ran a length of 3/8th hose to dump the warm water straight down right at the front of the tray. It cascades down and runs out the back. Kept my feet toasty warm today in 60 degree water.

I read about the tip somewhere here, so whoever you are: THANKS!!

Aaron
Click to expand...

Aaron,

Get off your ass, get your camera, and post a build thread in the Tech section on how we can benefit from your toasty feet-ginuity.

I thank you in advance.

-Sho "cold-toes" Nuff
 
SJBrit

SJBrit

Extraordinary Alien
Location
Bradenton, FL
ATS_Aaron said:
I drilled and tapped my water outlet and attached a 1/8th NPT to 3/8 hose fitting to it. I then ran a length of 3/8th hose to dump the warm water straight down right at the front of the tray. It cascades down and runs out the back. Kept my feet toasty warm today in 60 degree water.

I read about the tip somewhere here, so whoever you are: THANKS!!

Aaron
Click to expand...

60 degrees?!! That's not cold: you could fart on your feet and keep them warm in that! :biggrin:
 
You must log in or register to reply here.
Top Bottom