my new x2 does not start, does not click, does nothing when the start button is pushed. Jumping the solenoid terminals cranks it over just fine.When I got it there was about 3" of water in the engine bay, and it had been sitting behind a barn for at-least 4 years in the elements, PO said they started it a few months ago. What is the likely culprit for a seemingly dead starting circuit? possibles are: start buttons?, ebox?, solenoid?, wiring? Pretty simple circuit, wires between the ebox and solenoid looked fine haven't inspected any further.
650/X-2 Start button does nothing, likely culprit?
- Thread starter eeerieski
- Start date
Flyinbysti
Rad Dudes
- Location
- CT
I would do what lobster said and pull the face off and clean the contacts.
guiness92
▓▓▒▒▒▓▓▓▒▒▒▒▓▓▓▓▓▓
- Location
- South Jersey Shore
I just had this same problem too. It ended being that the wires going from the harness to the switch were corroded all the way down. I just spliced new wires in and it works great