Silicon Hose for Factory B Pipe to Waterbox

[joshuaeric]

Does anyone know where I can get some exhaust hose?

It is a 45 degree bend from my factory pipe to my waterbox.

Here is a picture of it on blowsion's website. http://blowsion.com/detail.asp?PRODUCT_ID=01-01-609

$50 for that piece of hose is rediculous.

I've heard the FPP replacement isn't that strong, so I am looking for a good replacement.

 

[oxnard111]

i have a stock hose that has been cut to length for a MOD chamber. if you are using the limited, you can trim it shorter. $20 shipped with hose clamps.

 

[joshuaeric]

Do you have a couple of them?

 

[#ZERO]

Here's an angled 4-ply silicone 2.5" to 2.0" reducer hose that will work for 20 bucks plus shipping. http://cgi.ebay.com/ebaymotors/2-5-...009QQitemZ190228148278QQrdZ1QQsspagenameZWD1V

They come in different colors too. :woot:

 

[Mouthfulloflake]

I was in the same predicament.

I found a truck radiator house for $22 at Oreilly auto parts, and cut the length to fit.
its held up fine so far, even when I ran it without water for a few minutes.

 

[joshuaeric]

Thanks everyone for the suggestions.

I found the exact hose I needed and just wanted to post it up here for anyone in the future that runs across this problem. I found them through ebay and then ordered directly from them. They had something like 5,000 transactions, so they appear to be a reliable source.

www.siliconeintakes.com

http://www.siliconeintakes.com/prod...d=905&osCsid=84f152d6b123645a1e7c55a1b528de3f

Silicone Reducer, 45° bend - 2.5" to 2.0" - Black
High quality 3-ply or 4-ply fabric reinforced silicone
Installer can cut silicone parts down to fit with a razor
Heat tolerance: -40° to 392° Fahrenheit
Burst Pressure: 200 PSI
Working Pressure: 50 PSI
Wall Size: 4 mm - 5 mm

PRICE: $19.99