Side Rail Bumpers

kawi kid

kawi kid

Location
Mesa AZ
I plan on doing a Jettrim mat kit with rail caps on my SXR and am trying to find the replacement bumpers people are using like on this ski:

http://www.pwctoday.com/showthread.php?t=374473

Ive seen it done on quite a few boats but cant seem to find where they get it from. Could anyone point me in the right direction and provide me with some tips? I just don't want to use the bulky OEM bumpers on the back corner or the SXR and really like the clean look of this. Thanks for the help!
 
kawi kid

kawi kid

Location
Mesa AZ
Exactly what i was looking for. Thanks for the quick answer! Debating about sponsons, just can't make up my mind if between bolt through like blowsion or screw on like Prowatercraft
 
XJCrawler

XJCrawler

Location
Edmonton, AB
The destroyers provide a little more width to the front of the ski. Helping with the additional weight of the triple. Aftermarket hulls have a little bit of sponson built in so they don't need the extra width of the destroyer.

Both sponsons work well, the destroyers of a more all around ride. The prowatercraft sponsons are for a more aggressive rider, I would run them on a buoy only ski
 
djkorn1

djkorn1

kidkornfilms
Site Supporter
Location
Cleveland Ohio
Take off all the bumpers and put Hydro-Turf on everything. Lighter & Cleaner looking...doesn't get scuffed up like the bumpers do.
jetski 031.jpg DjskiDaytona.jpg
 
You must log in or register to reply here.
Top Bottom