shortening steering nozzle

[Matt_E]

Riding without a rideplate (without knowing it, LOL) sucks, too.

 

[Waternut]

WHy didn't u say so? I have ridden my ski a couple of times w/out a steering nozzle and it plain ol sucked donkey cods. It did not turn worth a dam. LOL

I was waiting for a comment like this...LOL :Banane09:

 

[GIL]

Riding without a rideplate (without knowing it, LOL) sucks, too.

Really? I have not tried that one yet. Thank you for the tip-I will go plateless this weekend. LOL

 

[Waternut]

Riding without a rideplate (without knowing it, LOL) sucks, too.

Yeah I had one rip off in the past. I didn't really realize it at all when I was just learning to make a setup wake and jump it primarily because I wasn't planed off. However, every time I went to give it a lot of gas or get up to cruising speed, I couldn't figure out why I couldn't control the porpoising...lol.

 

[carbonjet]

I chipped my plate real bad after landing hard and hitting bottom, the ski was dragging me to the right, and then... Pow Bam Piff there goes the rest of it. It was not helpful. :1zhelp:

 

[shawn_NJ]

Did anyone ever try shortening the nozzle? I am debating going for it, but to cut an $800 trim system has me thinking twice...








And rideplates are overrated.