Hogggman
Stock Sucks
- Location
- White Lake MI
I know I should ask this on the other site but I dont really go there anymore. How do you change the wear ring on a 96 Spx x4 hull?
Sea Doo pump question
- Thread starter Hogggman
- Start date
ger87410
How did I get here?
- Location
- Fort Worth
???
Cut out the old and put in the new.
Should be the same as about any other pump.
Cut out the old and put in the new.
Should be the same as about any other pump.
Hogggman
Stock Sucks
- Location
- White Lake MI
Does it have to be pressed in with a press?
ger87410
How did I get here?
- Location
- Fort Worth
U pulled out the old, yet?
If not, don't worry about getting the new one in yet.
U should be able to use just about anything to get the new one in. Personally, I'd try a vise first.
I've never replaced a wear ring. All my advice here comes from supposition and theory.
If not, don't worry about getting the new one in yet.
U should be able to use just about anything to get the new one in. Personally, I'd try a vise first.
I've never replaced a wear ring. All my advice here comes from supposition and theory.
No. Put a 2x4 across the ring and hummer it down with a rubber mallet.
Endo
Non-tree hugger
- Location
- Northeastern Indiana
Freeze the new wear ring prior to installing. Goes in a lot easier.
ger87410
How did I get here?
- Location
- Fort Worth
The only difference is that it's plastic.
I have only done one seadoo wear ring but the plastic one I replaced it with just dropped in (slip fit) I had to put in a couple sheetmetal screws to keep it stuck in the housing. To get the original out I cut through it (carefull not to cut into the housing) in 2 places lengthwise then just pulled it out (screwdriver helped).
This is about as standard as you can get for wear ring replacement.