Primer fitting question?

Tadpole1975

Tadpole1975

The clown has no penis!
Location
Palmer, NE
I am in the process of installing a primer pump. I removed my choke rod and have a plug for one side of the throat and the barbeb fitting for the other side. Was just wondering how I keep the fitting and plug in place. Should I use red loctite, ping or pinch the sides of the choke rod holes? I would hate to have the fitting or plug fall out. Thanks in advance.
 
Waternut

Waternut

Customizing addict
Location
Macon, GA
I couldn't get the hammer thing to work without bending the fitting so I just put the fitting in a drill and rotated it around some sand paper to file it down bit by bit until it fit nice and snug.
 
SXIPro

SXIPro

JM781 Big Bore
Location
Here on the 'X' mostly
From JSS website:

13. With holes properly sized, install fitting in desired location. If fit is a little to loose, clean the holes with acetone and apply super glue to the fitting before installation

From JetSkiMechanic.com:

If you want you can add a small amount of lock tight to the outside of the brass fittings before you install for that perfect install, but they should press fit right in place.

I know I read somewhere that people have used JB Weld, but I can't locate the source right now.
 
Tadpole1975

Tadpole1975

The clown has no penis!
Location
Palmer, NE
SXIPro said:
From JSS website:

13. With holes properly sized, install fitting in desired location. If fit is a little to loose, clean the holes with acetone and apply super glue to the fitting before installation

From JetSkiMechanic.com:

If you want you can add a small amount of lock tight to the outside of the brass fittings before you install for that perfect install, but they should press fit right in place.

I know I read somewhere that people have used JB Weld, but I can't locate the source right now.
Click to expand...

I was wondering about jb weld myself.
 
You must log in or register to reply here.
Top Bottom