chrisdoc0608
insulting
- Location
- rocky mount, nc
what can i use to polish a cofman exhuast pipe? i guess its aluminum but idk, so what can i use?
polishing exhaust pipe
- Thread starter chrisdoc0608
- Start date
- Location
- Melbourne, FL
to do it right you need to buy quite a few polishing wheels ($6 each) and compounds ($10 each). I would start with a 180 grit greaseless compound and then move to 240 grit. From there you will need to go through the polishing compounds. Go to www.caswellplating.com That's where I got all my stuff and it ended up being pretty expensive to get the full setup.
onesojourner
I use a thumb throttle.
- Location
- springfield, mo
I just wet sanded mine and used mothers aluminum polish. I spent maybe 10 bucks and I did by hand in the hull. it will get water spots every time you ride though so be prepared. I am going to experiment with some waxes and such.
chrisdoc0608
insulting
- Location
- rocky mount, nc
it doesnt have to be a mirror finish, i just want to brighten it up better than it is now. will any aluminum pollish work?
onesojourner
I use a thumb throttle.
- Location
- springfield, mo
yes anything will work and it will be a mirror finish I paid about 5-6 bucks for the mothers stuff and it was just like a mirror.
wayne
wannaroll
- Location
- Mesquite, Texas
http://sites.browsermanaged.com/folder5077/index.cfm
this is some pretty good stuff. they have it at the auto shows.
this is some pretty good stuff. they have it at the auto shows.
- Location
- Toronto, Canada
0000 steel wool
chrisdoc0608
insulting
- Location
- rocky mount, nc
i just went to the motorsport store that i had a gift card to for my b day, and picked up some kind of soft aluminum polish, i did a little of the pipe for a min, and it looks a lot better. thanks for the help