Oneways: pump dump or out the back?

[SXR-FOREVER]

putting dual oneways in the SXR and wondering whats better? I think out the back looks better but I could see maybe that the pump dumps have a lesser chance of blowing out?



thanks

 

[Idok]

my thoughts exactly.

 

[SXR-FOREVER]

so...anyone?

 

[Brenden]

how far are you into the back of your hull??
if your down that far and can easily have acess to the pump sides
then go for it
yet if your not just go out the back
i dunno how much harder that foam is to cut tho

 

[SXR-FOREVER]

well I cut the back of the hull to shorten it so I can do either..

I'll just go the pumpdump, I dont want to blow one out in Sebastian this year.

 

[Boris]

If you run them out back and are worried about blowing them out than just add scuppers on the outside.

I know there is extra cost involved but it works for me.

 

[Brenden]

if your tapering the hull dont do it
if your cutting straight do w/e works for ya

 

[yankeeboy]

Out the back is definately easier, but more likely to blow. If you were cutting your tray up for refoaming and can easily maneuver the drain in there, i say pump dump.

 

[Goose]

do a pump dump.

 

[SXR-FOREVER]

pump it is then, thanks for the input guys!

I am going to use 2 Homedepot/menards check valves and the black (abs? its alot lighter than PVC) pipe to run it. Whats a good glue to glue the abs to the side of the hull? Should I just glass it in?

 

[Goose]

3m5200 should work fine

 

[Crab]

pump it is then, thanks for the input guys!

I am going to use 2 Homedepot/menards check valves and the black (abs? its alot lighter than PVC) pipe to run it. Whats a good glue to glue the abs to the side of the hull? Should I just glass it in?

Thats the same setup I used on the X2, abs for its lighter weight also. When I install it back in my rn, I will leave it out about 1/8" so there is something to caulk to. Has anyone actually blown one out (1.5 inch)?

 

[Mike W]

If you run them out back and are worried about blowing them out than just add scuppers on the outside.

I know there is extra cost involved but it works for me.

X2. Plus it looks alot betterurr:

pump it is then, thanks for the input guys!

I am going to use 2 Homedepot/menards check valves and the black (abs? its alot lighter than PVC) pipe to run it. Whats a good glue to glue the abs to the side of the hull? Should I just glass it in?

I used 404 epoxy filler to glue in my scupper. That thing is going NOWHERE. I guess 5200 will work just fine though.

 

[SXR-FOREVER]

Well I cut my hull at an angle so unless there is a scupper that will stay closed I am SOL.

What do the cutback freestyle boats use for scuppers??