LPW/Paul Lehr A+++++++

SXIPro

SXIPro

JM781 Big Bore
Location
Here on the 'X' mostly
So I had a fatal air leak and melted my rear piston. Shot Paul an email and we discussed the options and settled on a rebore to 82.5 per hole, some Pro-X pistons and the rest of the necessary parts for a top end. I was hoping to have it back in time for this weekend, but figured it would take a miracle. I shipped my cylinders and carbs to him.

He ordered up my parts in advance. He got my cylinders in the same afternoon the pistons arrived in Georgia. He turned it around that night and shipped them the next morning. :Banane09:

He has been awesome, I had a million questions because I've never destroyed a piston before or replaced one. He answered quickly and with good humor. I'd send him emails at 9:30 at night hoping he'd respond to me the next morning, but he'd get me an answer in ten minutes.

Got my cylinders and pistoms yesterday, put most of it together last night. Finished it up this morning and put a tank thru it today. It RIPS.

So now I have a 727 intead of a 701. I am a 727 Jet Pilot :smoker:

So to make a long story short; Paul you ROCK!!
 
Last edited:
SXIPro

SXIPro

JM781 Big Bore
Location
Here on the 'X' mostly
It was already ported by him back in the days of JR Magoos before I owned it. He noticed that it didn't have all the little things he does to them now so he updated it for me for $0.00. He's awesome. Even today I emailed him because I have a little hesitation in my midrange, I think because when I had my ski apart I filled in the intake manifold crossover. I told him not to worry about it and send me some info on Tuesday, because the ski was plenty fine low end and top end plus I was thrilled just to have it to play on for the long weekend. Sure enough he emails me back minutes later with some carb settings to try out tomorrow.
 
You must log in or register to reply here.
Top Bottom