W
wydopen
Guest
dont take the head of..just remove the plugs...
it just sank....
- Thread starter DAG
- Start date
dont take the head of..just remove the plugs...
- Location
- Round Rock, TX
I love Seafoam and thats what I would use to fog it but yes the people at NAPA can tell you were the fogging oil is. To fog the motor have the motor running and spray the oil down into the carbs untill it dies. I would do this a few times. THEN remove the plugs and spray down the sparkplug hole. you dont need to remove the head
crc makes good fogging oil. go to west marine store off exit 36, they have several types.
spray it in the plug holes and turn the ski over to lube it.
then get her going and ride (which hopefully you have already done!)
when done, with motor ruunning you spray it directly into the carb to lube crank+case and displace residual moisture.
motor will cough, smoke and choke out.
start her up and repeat a few times before letting it sit for any length of time.
spray it in the plug holes and turn the ski over to lube it.
then get her going and ride (which hopefully you have already done!)
when done, with motor ruunning you spray it directly into the carb to lube crank+case and displace residual moisture.
motor will cough, smoke and choke out.
start her up and repeat a few times before letting it sit for any length of time.
DAG
Yes, my balls tickled from that landing
- Location
- Charlotte, NC
Done!, hopefully she's not binded up in the morning.
I ran it a good 40minuts nice and hot (in the water of course). and applyed the fog within the hr of taking it in. it was still warm to the tuch when i started foging. used 3/4 can. BTW: the spray nossle shot 2 perfect streems coming out like a V. Perfect for doing both carbs at once... i could not get it to choke out unless i let it idel while still spraying. Damn were you right about the Mosquito spray. It looked like a military grade smoke bomb was set off. at least 600-100-cubic foot of dence smoke screen when all said and done.
Crossing fingers
I ran it a good 40minuts nice and hot (in the water of course). and applyed the fog within the hr of taking it in. it was still warm to the tuch when i started foging. used 3/4 can. BTW: the spray nossle shot 2 perfect streems coming out like a V. Perfect for doing both carbs at once... i could not get it to choke out unless i let it idel while still spraying. Damn were you right about the Mosquito spray. It looked like a military grade smoke bomb was set off. at least 600-100-cubic foot of dence smoke screen when all said and done.
Crossing fingers
- Location
- Mooresville, NC
You will be fine, don't worry. I have sunken skis multiple times and done what you did, you basically just need to make sure to run it for 30 min or so like you did to get rid of any crankcase moisture!
C-Rock87
Water Junky
- Location
- Boise, Idaho
sorry if I missed it...did you give the story on how it almost sank?
chookc
X
- Location
- Perth Wetsern Australia
You can just use your good old two stroke oil that u use in the fuel and squirt into carbs does the trick.