Impeller removal tool help

[theRabbitbutton]

Anyone know what tool I can use to remove this impeller.... can’t find a tool for this. It has three holes instead of four so I would need a 3 prong tool??? Thanks

 

[G-Body]

I had an impeller like that and I made a tool out of black iron pipe. It was either 1/2" or 3/4" pipe and I cut the 3 prongs into it. I meant to weld a nut on the end, but I was in a hurry and just grabbed the pipe with a pipe wrench.

 

[theRabbitbutton]

Also FYI pulled the pump out of my B1

 

[Christian_83]

My bet is, a nujet impeller
https://www.ebay.com/itm/NUJET-YM-B5-5-NUJET-IMPELLER-YAM-155MM-/274101243250

 

[Christian_83]

 

[JetManiac]

I had an impeller like that and I made a tool out of black iron pipe. It was either 1/2" or 3/4" pipe and I cut the 3 prongs into it. I meant to weld a nut on the end, but I was in a hurry and just grabbed the pipe with a pipe wrench.

We did the same.

My bet is, a nujet impeller
https://www.ebay.com/itm/NUJET-YM-B5-5-NUJET-IMPELLER-YAM-155MM-/274101243250

That is what I think also.

 

[G-Body]

Yep when I pulled my impeller out it was a nu-jet destroyer impeller.

 

[theRabbitbutton]

You nailed it!!! Just took the impeller house off

 

[surfjunkie]

the shop that does my oil changes tack welded a nut on then cut off nut and cleaned it back up .... worked

mine was a nujet

 

[theRabbitbutton]

Thanks for all the help here.... got a rather large pliers on the nujet and turned it into an oldjet....