Help with SJ cooling?

[IceRocket1286]

I am runing single cooling on my superjet, its stock except the factory dry pipe. I have one pisser from the pipe, thats it.


I got a new used stock head today from magoos, and its tapped for another cooling line to dump out of the hull, aka another pisser line.

I am wondering If I can run my single cooling setup and dump the NEW pisser line out of the ski without running my engine or pipe TOO hot. I dont want to overheat anything or burn a the coupler at the manifold.

its ot a problem to block the extra pisser outlet for the season, or until I get around to taping for dual cooling...aka my ski breaks and i have a reason to take it apart.

For now I'd like to run the extra pisser if can, but if I shouldnt, I wont

Thanks!

 

[Mile9c1]

Why bother with the 2nd pisser if it's running well now?

 

[waxhead]

take the two pissers off the head and then join them into the bottom of the header pipe
free rpm if you do this

 

[sflsurfrider]

what wax said.

 

[IceRocket1286]

Why bother with the 2nd pisser if it's running well now?

The 2nd pisser is already tapped n the head, wasnt my doing.

Wax....I have no head pipe, its a dry pipe. Just a manifold and a chamber. Should I run it to the bottom of the chamber where my other head line goes?

 

[romack991]

tee the two lines that are coming out of the head together, then run it to wherever you have been.

 

[IceRocket1286]

ok, will do!

 

[waxhead]

as above
if you just tee them together and run to where the other pipe is already going
it will be fine
yemahas with water out each end of the head rev better

 

[oxnard111]

good to know