Help with flush kit

[Aka Kane]

I need to know where to get the other end that attaches to the hose. Here are pics of my flush kit...

 

[550 SLUT]

try hot products

 

[meatball]

its a quick release version. Try bringing it to your local dealer if you have a good one around, or try www.atlanctic jet sports. OR just but a garden hose attachment with the screw-on cap and put that on instead, those quick-attachments have a habit on leaking (ie squirting everywhere) and are more hassle then they are worth IMO.

 

[Waste Land]

You ride salt alot?

 

[demolition_x]

its a quick release version. Try bringing it to your local dealer if you have a good one around, or try www.atlanctic jet sports. OR just but a garden hose attachment with the screw-on cap and put that on instead, those quick-attachments have a habit on leaking (ie squirting everywhere) and are more hassle then they are worth IMO.

thats what i would do. they sell them in h depot

 

[Aka Kane]

No,

But I would like to be able to put it on so I can run it on land tuning or whatnot. I ll get the screw on type. . Thanks

 

[Idok]

does this ski have a bilge pump on it? I remember the last episode on the B1....

 

[Aka Kane]

Haha yes it does. Man I just did not want to cut into the hull on the B1. It was so mint! I will however be adding another pump to go in the rear of the ski, and maybe move one to the very front....Just so little room to work with in this thing

 

[Ollie Rastabean]

That is a Colder Products (CPC) disconnect.

If you go to www.colder.com you can find a distributor and pick one up.

-Ollie

 

[Aka Kane]

Another thing,

My flush kit is installed into a niple on the exhaust? IS this right? I ll take a picture

 

[Aka Kane]

Here is the picture.

 

[waxhead]

dont tune on the trailer

you will end up lean

 

[Aka Kane]

I know, I just need to run it on there, because I think I am having a fuel delivery problem. I was on the lake, and I would have too prime it to keep it running and get back to the dock.....Maybe I was low on gas, idk, I want to be able to have it idle and check it out.

 

[meatball]

yes thats installed correctly, not many people are aware yamaha put a screw in that hole for the intention of the end user removing it and putting in a brass nipple (like what you have). Although t-ing in where the pisser goes works just as well (if you dont have a pisser that is)