Custom/Hybrid glue that does not eat blue/pink panel foam?

[WAB]

What was it called?
I saw it posted within the last couple months but can't find it now.

 

[Matt_E]

Eh home improvement stores sell eps safe glue.

 

[jeremy chambon]

gorilla glue

 

[D-Roc]

I used pl300. Panel glue. I glued the foam to the sides of my hull and shaped them into sponsons. You need to attached the foam to the fibreglass and then seperate it for 5 minutes to vent. Then put them back together. It's a permanent bond. Not sure of your application but it bonds very well to properly prepped fibreglass and whatever the bottom deck of a superjet is.

 

[WAB]

Thanks!
Yeah, making sponsons from a few layers of panel foam.
I thought there was a sprayable/paintable glue. Wanted something thin that I could sand right through in the layers of panel foam.

 

[D-Roc]

I used 2" foam and 3 layers of glass over top. I am laying up a little more on the leading edges this winter as three layers almost wore thru with me dragging the ski up rocks and what not. I don't know about gluing several layers together. I used the 2" which made my ski 4" wider. That's wide enough over stock IMO.

 

[Idok]

try polyester resin....but clean it well with acetone first

 

[js/sj]

try polyester resin....but clean it well with acetone first

HAHA funny man

 

[smokeysevin]

3m super 77 works well, I have been making a rear seat cowl for my kawi stx and I had to use it. Don't get the loctite stuff it will melt it.

Sean