capping off stock superjet micro waterline

[SharkB8]

Where can I buy a cap to seal this thing.....

Also need one to cap off the primer fitting on my flame arrestor adapter.

Tried the local hardware stores - no luck.

 

[motobehrens]

auto parts store. might be called a vacuum fitting cap.

 

[Yohns Kustom Fabrikation]

Check the auto parts stores. I used normal vacuum caps like for automotive carbs.

 

[Yohns Kustom Fabrikation]

Beat me to it.....

 

[SharkB8]

Thanks.

Thanks.

 

[Big Kahuna]

take a short piece of the hose, fill it with silicone. Free.

 

[SXIPro]

take a short piece of the hose, fill it with silicone. Free.

I went even more redneck..piece of hose, doubled it over and tie-wrapped it.:tomato:

 

[QuickMick]

clean the nipple and inject silicone in it is what I would do.

 

[smoofers]

I went even more redneck..piece of hose, doubled it over and tie-wrapped it.:tomato:

That's what I did too. works like a champ... cost = nothing

 

[onesojourner]

mine had a hose with a screw in it. Ketsair made me use a cap though when he saw it.

 

[oxnard111]

mine had a hose with a screw in it. Ketsair made me use a cap though when he saw it.

thats what I use. piece of primer line with a screw.

 

[ticega306]

if ur into RC cars, antennae tube caps work great. nice and snug!

 

[SharkB8]

I had some hose with a screw in it but it just looked too ghetto.

I checked two local auto parts stores didn't have caps that would fit.

HOWEVER..... I have some extra primer line and a spare pisser with a small connector on it - I'm just going to route the water overboard.