WaveDemon
Not Dead - Notable Member
- Location
- Hell, Florida
the mounts are bad. I wouldn't want to ride with mounts that twist off when you unbolt them without power tools.
budget surfboat/firstboat- comin along
- Thread starter brett
- Start date
brett
-------------
- Location
- Ventura,ca
wydopen
onthepipe
- Location
- Goleta the Goodland
we took chads off on his square and now i think that with the hole there it dosnt get enough suction to push water for the cooling..he filled it with 5200 but it blew out..
wydopen
onthepipe
- Location
- Goleta the Goodland
and when u take the mounts off you can hold the rubber part with some channel locks while you turn the bolt
stanton
High on jetskis.
- Location
- atascadero,ca
we going to reinforce that while its stripped??
bring me the hull and ill bust it out quicklike
SLH#2!
bring me the hull and ill bust it out quicklike
SLH#2!
stanton
High on jetskis.
- Location
- atascadero,ca
so you want to use cheap resin, like the home depot bondo polyester?
will that stick???
will that stick???
wydopen
onthepipe
- Location
- Goleta the Goodland
Polyester WILL NOT STICK :smashfreakB:
stanton
High on jetskis.
- Location
- atascadero,ca
i didnt think it would
brett
-------------
- Location
- Ventura,ca
uke:
brett
-------------
- Location
- Ventura,ca
works for me
brett
-------------
- Location
- Ventura,ca
got new prop in, hull fixed, bracket area reinforced, and im waiting for a flywheel puller to put in different stator/ flywheel because the 61x motor i bought fried the wire somehow. electronics is not my forte so i dont know, but for some reason the stator wire got really hot and melted. i have a 62t flywheel/stator setup from my old motor i was gonna throw in there. anyone have any ideas on what caused this?
brett
-------------
- Location
- Ventura,ca
i pulled the flywheel cover and it was a mess in there! i can see why the wires burned up. there was oil covering the stator. i got scared and thought a crank seal was bad but after closer inspection and cleaning im pretty sure it was the oil injection pump.
brett
-------------
- Location
- Ventura,ca
new impeller in
quicksteer
quicksteer
brett
-------------
- Location
- Ventura,ca
rn bracket and hood hooks installed. just got done puttin sj batt cable and switch cable to the blaster ebox. rn pole cut 2''
brett
-------------
- Location
- Ventura,ca
pole done motor ready to drop in! still gotta cut the threads in the pole bolt
brett
-------------
- Location
- Ventura,ca
pump, grate and plate installed
brett
-------------
- Location
- Ventura,ca
got the motr in and ordered turf...then i got a call back. no more molded diamond till may ~10. we're almost done so im thinkin we'll go with waffle cut
wydopen
onthepipe
- Location
- Goleta the Goodland
brett
-------------
- Location
- Ventura,ca
so freakin close!!!i need an RN pole bolt. makin the sn bolt work is becoming a nightmare and i think we fvked it up for good now