Blaster 1Triton Midshaft bearings
- Thread starter Octane
- Start date
godocgo?
- Location
- mobile alabama
lee did you sell the one you had?
yes, i just got paid today. it sold on ebay to someone in england. it may be octane.
i was working on my stuff so i had a chance to look at them side by side.
Octane
X
Cheers Lee, It`s Me. Rob @ Jetski mechanic lists two sizes 93-94 and then 95-96 trying to work out which. It will be used over here in Scotland, On Loch Lomond. I know, You`ve never heard of it....LOL
We have only one yami dealer up here and custom work is not there bag so any info to help rule out guessing would be a major bonus..
We have only one yami dealer up here and custom work is not there bag so any info to help rule out guessing would be a major bonus..
Last edited:
you got me there, it came out of a mod hull. i mean a total aftermarket hull, so i have no idea which is which. it is boxed up and awaiting mailing tomorrow at the post office. they are officially closed today. another holiday none of us have off, except our government. 
SUPERTUNE
Race Gas Rules
- Location
- Clearwater Fl.
If I haven't lost my memory...I think the triton billet housing uses the early 650 bearing (thinner than the 701 now used) I think its been like ten years ago the last one I did...
Octane
X
You were correct Chuck, But as luck would have it. Who ever machined these units was clever enough to allow both size bearings to fit with another circlip groove cut in. Very clever and i like the forward thinking.
Just out of couriosity how will this feel in use, I quess it will feel rougher now the rubber damper is gone.
Any tip`s on installing/Shiming it up.
Just out of couriosity how will this feel in use, I quess it will feel rougher now the rubber damper is gone.
Any tip`s on installing/Shiming it up.