Best under tray cooling lines?

[RoyalFlush@PCB]

damn, I had forgotten about that!!!!!!!!!

My first Superjet!!!

Paul even drove half way to meet me---he's a hell of a guy. :arms:

 

[NathanMoore]

its bad for the same reason that space art with spray paint and stencils is bad.

:haha: :haha:

 

[Idok]

alright...pix of the tray...


so it was PAUL that did this!?!?! :grumble:





tonite I shall grind the edges, superglue the tray in and get it all prepped for glass....

then fill a couple of small area on the underside with 5200...mainly the screw holes from the Fin' PUMP SHOE :bs2:



:biggthumpup:


then tomorrow the glass love begins

 

[Big Kahuna]

one of them was a trim cable tube. 2 coolings and 1 stock bilge line.

 

[RoyalFlush@PCB]

so it was PAUL that did this!?!?! :grumble:

I can't say that it was Paul that did it, but it was not me. I installed the scupper and the footholds, so flame away if those are f'ed up. :biggthumpup:

 

[Idok]

one of them was a trim cable tube. 2 coolings and 1 stock bilge line.

which was the trim?



chic...the footholds and scupper install looked good.........there was some leakage thru the screw holes from the scupper outlet and fancy blowsion outlet.....i 5200'd them, and will use a slightly larger screw when I reinstall....

 

[Big Kahuna]

just lay some ducktape over them, once it gets wet that adheasive will turn to goo and you will be just fine!

 

[Idok]

just lay some ducktape over them, once it gets wet that adheasive will turn to goo and you will be just fine!

good tip!