Search results

Maybe try to find a few people that can piggyback it, in other words , one guy is going from Dayton to South Carolina , another is going from South Carolina to Georgia and another is going from Georgia to Fl;ordia.

I am sorry but I feel its like going to a drive through , don't take my money then make me to wait 30 minutes and park over to the side, tell me it's going to be a wait up front so I can make up my own mind and choose another option if I want to. I know in my case I would have gone with another...

Pretty sure the stock fittings are NPT 1/8"

Not sure but I have a nice clean Solas here I can post the pitch specs at lunch time today for you with a pic.

No way to tell from those pics but yes that does look like a Seadoo throttle linkage, I am running Seadoo carbs on my big pin 750 with a stock SXR manifold

It goes under the HOOD blow off cover

This sounds like a good plan.

Now don't be sad, cause one outta a hunnedd ain't bad

Sadly we have all seen this happen before, does the name Waterdawg ring a bell with anyone here?

There is no marine engine , the engine used in the skis was a converted snowmobile engine.

Those starter solenoids are rebuildable pull it apart and have a go at it they are very simple.

What size Cayuna, they were also used in snowmobiles and hovercraft

You should be good to go.

Several things it could be , tilt switch , throttle sensor, temp sensor all will make it not fire ,that is why Jason said put some slack in the throttle cable , if it senses the throttle is open at all it will not fire. the tilt switch you can unbolt it and check it out, the temp sensor is a...

Post a pic, I or someone else here could make you one, it's not like I haven't done it before, thats a pic of the 650 pump tunnel I put in the 300sx, I popped a mold and laid it up

Timeserts from my recolection are 2mm bigger outside thread than inside thread on a 64x cylinder you use 8mm x 1.25 timeserts to screw into the 10mm x 1.25 exhaust manifold holes, I hope this helps

I had no idea this thread even still existed until someone left a like on it today.

61X CASES OR 62T CASES ?

Been there done that on a Yamaha 1100 that the seals kept popping out on, sealer on the cranks seals made the seals pop out easier, it did the opposite of my intention, do no do it.

I will see if I can find it , it would be fairly easy to replicate if you had a 3d printer, it's kinda like the Malco but the fingers are much thinner so it can produce much finer detail.