Search results

Bump, modify how?

I believe a 5/16 will fit perfectly.

You can turn them, but you do not want turn them by the nipple. You have to do it from the opposite side. His carb looks new, or low hours, so he should be safe.

At what point do you add fuel line restrictors, and how do you determine the correct fuel (flow) requirement? This is for my recreation setup, but it's a LPW sport port with dual (retail) 44s. I hope to do some tuning this weekend, but I started thinking about this as the last thing I need to...

We have a forum specifically for the Octane. I suggest you start there: http://www.x-h2o.com/forumdisplay.php?f=83 However: OK well i just bought a 2003 polaris Did i make a mistake ? Depends, to each his own. Some like, some hate. or a great find see above answer I just need info about the...

Is the aluminum cone for the blaster only, or do you use the rubber on the blaster as well?

Received the order, and it was accurate. No missing parts. I think their communication is horrible, but do have great prices. They should have contacted Oyster to let him know his $500+ order was held up by 1 part. 1-2 weeks is one thing, nearly a month is another. If you want better service...

Tracking number was provided via email. I only ordered motor shims, so it wasn't a big deal (not alot of $$), but it's holding me back on getting my ski back in the water. Oyster, I'd call to see what the holdup is. I think communication is a problem with them, but do seem legit. We will see...

Just called and received someone on the phone, they said my order was going out today. Asked for a TN and they said one would automatically be sent via email once shipped. I'll call again tomorrow if no tracking number.

Folks, any updates?

If your not installing footholds you might want to think about either keeping the bottom stock turf installed and install Hydtoturf on top, or get some foam and turf on top of that.

Has anyone reached this place since the 17th?

I know there are at least 2 different sized dowel pins used on the SJ, anyone have the other. More specifically, anyone know what is used for the pump to hull and pump to impeller housing.

I ordered them, and they are rounded at the ends (tips are not flat). Thanks for the correct numbers, I'll get it exchanged. Per McMaster site:

Check this thread: Hitch Carrier

Think about the old school forums that have multilevel replies, where it seems impossible to follow a thread conversation. (See, my reply is post 1 of Grif's question. Hybrid/Threaded is just stupid) 1 - Asdfasfd... 03-24-2008, 07:54 AM - re: Asdfasfd... 03-24-2008, 08:16 AM - re: Asdfasfd...

This reminds me of: Waterlogged foam? Ha, I scoff at your measly wet foam. Read the thread to find out what areas to seal.

What did the Easter Egg say to the boiling water? It's going to take me a while to get hard, I just got laid by a chick. hahaha.

THANK YOU!!!! (Best seasons of SNL was w/ Mike Myers, David Spade, Chris Farley, Adam Sandler, Rob Schneider, and Kevin Nealon)

That's $2700 USD. http://finance.yahoo.com/currency/convert?amt=3000&from=AUD&to=USD&submit=Convert