Need your hitch hauler dimension

[DaUpJetSkier]

Im gonna pick up the stock tomorrow at a friends metal shop. When I have them cut the 2" stock going into the receiver I want to only do it once, so ski is about 24" wide right, then i need to add space between ski and bumper then the amount going into the receiver. I guess width of steel holding bunks doesnt matter much. The more I think it may just be a guess and test project, but give me your dimensions anyways if ya got em.

 

[marz831]

Mine is 30.5 inches from the end that goes into the hitch to the end of the rear bunk. It is a tad bit long though. I would like it if the ski sat a little closer to the truck.

 

[AtomicPunk]

not mine.. but I thought it would help.

good luck and post pics when you are done.

 

[D Slicker]

I will take a picture of the one i build tomorrow for you.

 

[surferdude345]

How well do those work? Are you have a metal shop fab it up - whats its costing you around?

 

[D Slicker]

not mine.. but I thought it would help.

good luck and post pics when you are done.

Change the 12" to 14" it will fit allot better.

 

[Speedfreak]

Ill try this again. I typed a bunch of stuff last night but the internet went down before I posted it up.

My 2 inch stock is 30 inches long. Which gives enough room for a trailer to clear the ski. There is less than an inch when you slide the class one receiver all the way into the 2 inch stock.

And the stabilizers are covered in 2 inch PVC so the ski is only 2 inches off of the rear bumper on an Avalanche. The bumper touches on one side and the ski on the other.

Here is a picture.

 

[michael950]

Check this thread: Hitch Carrier

 

[DaUpJetSkier]

so how far should should I measure for the bunks, 14"? Im gonna get 30" of 2" stock then a few feet of angle iron 2" on each side, maybe some rebar or something like it to go from the end of each side angling down to the receiver bar.

 

[Rickster]

For $275 shipped, you cannot go wrong.

http://magnetatrailers.com/

A couple of us use these down here, and I love the one I have! :cheer:

 

[Speedfreak]

so how far should should I measure for the bunks, 14"?

The center of the rails should be (for a superjet) is 12 1/4" center to center. That is where mine are and the 3 inch pipe fits perfectly. I just hope this hauler works on my new SXR

For $275 shipped, you cannot go wrong.
http://magnetatrailers.com/
A couple of us use these down here, and I love the one I have! :cheer:

That is a great price. I spent almost $250 in metal when I built mine.

 

[D Slicker]

The center of the rails should be (for a superjet) is 12 1/4" center to center. That is where mine are and the 3 inch pipe fits perfectly. I just hope this hauler works on my new SXR



That is a great price. I spent almost $250 in metal when I built mine.

i am 14 outside to outside and it is perfect. It cost me 100 bucks for metal and wood.

 

[Vumad]

Mine is 30.5 inches from the end that goes into the hitch to the end of the rear bunk. It is a tad bit long though. I would like it if the ski sat a little closer to the truck.

Can you drill a new hole an inch past the current hole?