Search results

I would only use cabosil for heavy duty filling , if you have something like a chunk missing or a gouge then use cabosil , but cabosil is a total PITA to sand , I use phenolic micro- balloons filler , specifically the SM fairing compound from US composites , it is the best I have found thus far...

Take a look at this thread , hopefully it will help you some the chines were ground down pretty well on that one. https://www.x-h2o.com/threads/650sx-rebuild-and-restoration.207873/

It's that time again , this year I am doing gardens in three different locations and planting mostly from seed , ALDI has a limited variety of seeds but the seeds they do have are 59 cents per pack, so far I have planted watermelon , cantaloupe and bell peppers from last years saved seeds ...

I made these two planters yesterday to hang off of the ramp , they just hang from the ramp with metal clips , I will probably make three more , there are squash planted in them right now but later there will be flowers in them. I also made the planter in the second two photos , it's more of a...

What parts are you still looking for ?

You haven't provided enough information about what was done to make any real type of determination , personally I would be looking for an air leak , you have already pulled the engine apart so you can't check it now , but I would do a full teardown, crankshaft seal replacement and air leak test...

Yes I did find a couple of intakes and used modified Mik 38 Seadoo carbs on them

Look for a set of 40 Mikunis off of an SXR and the matching intake manifold . Those would be pretty much plug and play and run really well for you .

I would feel a lot better about this if you can flip the handle to the other side and shorten up the distance it sticks out from the vehicle by that much , I could also see an option to remove the handle altogether and make a piece with a nut welded onto it where you can raise and lower it with...

Yes most 98 and up model XP's are Limited and came with 951's , the 97 came with a 787 , the exception is the 951 DI , it's called a DI and not a linited .

The one I have here is for a Waverunner XL , I am supposed to have one but I believe it is at the shop at the lake, I will check and see probably Saturday and report back.

Last time I talked to him it was on here and he said yes he is still making them as a side project , basically if you want a set you have to give him some time to make them , he went out and got something called a life , whatever that is. At any rate he contacted me on here , your best bet is...

Maybe where you are at it is, around here you would be hard pressed to find a company with a printer that big , I would almost say that there are not any in this state.

I will post pics here tomorrow around lunchtime.

Since it's maroon I am guessing old body style , I think they changed in 99 to the GPR hull , at any rate I will dig it out and snap some pics, it's been stored inside for some years.

I always found this vid quiet interesting.

I have a trailer that holds five, it is quite tongue heavy, it also is very heavy duty and it pulls like a dream. Regrettably the photos were posted with Photobucket so I can no longer access them. https://www.pwctoday.com/forum/general-interest/individual-builds/224082-

Without access to that giant 3D printer what good is the file ?

I believe I may have one in Maroon but what GP year is It , 97-98 ?

You want a bit of tongue weight so it doesn't fishtail , can you still pick up the nose of the trailer, if so . not too much tongue weight.