Search results

i will be at grand haven or ludington this sat jumping boat wakes. the great lakes are COLD but the in land lakes are just a wet suit and shoes.

Smoked meats!

Chris frank is still working on the extremely complex circuit board for the gloves. We all want a a pair of magic hands! You should be more intersetted in the hydraulic steering system

I'm sure it's a 1.5. I went through the whole box of springs of the dude that run wave rave last year and only one spring got me that low and looking at the chart it says it wasn't possible. But it got checked many of times and got a lot of springs the same color put in it and we could get a...

Well I'm running 12 and it ran crisp since my stator side was leaking I didn't have as much crank case pressure to work with I had to be low and when I got a run away I knew I had a seal going bad.

I have a 61x/61x stock port current set up is a single 44 with a 1.5 needle. At the end of the year last year I was having pop of issues and end setting the carb up for 12psiif I recall correctly. Everyone is saying that was really low for a motor with just a b pipe. So I took the fly wheel...

Yeah just about every Sunday there is a group that goes out. The is no coast gaurd and I have never seen the sharif.

I have ride a few times at GH and its fun with all the boat traffic. For the most part GH police are straight up dicks. But I have had no problem riding yet. Do any of you ride port Sheldon? There is a large group of us that rip on Sunday fun day

X scream makes a nice universal pick up but it's expensive for what it is

Look at the ARB tent I think it's 1600 ish and could be made to work easily I seen a thread in the hauling section with it on top of there included. I wanted one so bad when I was in to jeepen

Watch out for the fresh water sharks in Lake Michigan they are rare but extremely dangerous

All I know is it has the Reed stuffer if I make down to my shop this week ill look

^good to know.

Idk what size mines for I haven't looked that close at it. But I did notice two of the bolt holes don't line up with the case if I recall correctly. Sounds like this mite be a job for next weekend. Is tere a tech thread on intakes?

Chris thanks I think I'm going to try out the wet jet intake

Just the 44. Does the twin carb 61x setup make a big difference over a single 44?

I have a 144 mag with a 12/17 for my pump And don't quite have the money to finish my 62t/61x. So I have hook just looking for a little more snap.

Well I'm running a b pipe (mod) and 180psi. I have a wet jet intake on my shelf. Is it worth the gasket to put on.

Hi I have a stock ported 61x/61x what's the best intake to run I have a wet jet intake with the read stuffer. If I put that on will I need to rejet and adjust my pop off pressure or should I get a twin carb intake?

110 isn't low. its just fine if it hasn't been run in a while. there wont be alot of oil on the cylinder walls and that will cause low comp. if it ran fine when put away it will run fine now as far as compression goes