Search results

Cyborg http://www.x-h2o.com/index.php?threads/introducing-the-cyborg.190832/

Install a small extractor fan in the roof or a wall

The Cyborg has some unique features built into it. The pics shown are of the test ski, so some minor practical and cosmetic improvements have been done to the final product. The hull is 196cm(77.2") long, 54cm(21.3") high and 74cm(29.2") wide. 1. Integrated waterbox in right gunwale, no separate...

In wetpipes the exhaust gas is cooler which makes the pulses/waves move slower than in a drypipe, that is why a drypipe is longer for the same rpm and exhaust timing(The drypipe pulse that is moving faster must travel further to arrive back at the exh port at the same time as a wetpipe). The...

Engine vibration impacts the check valve far more easily on the direct hole. The passage in the offset valves dampen the effect of vibration on the fuel

Make sure you use hot water, the holes/cracks will open more

0.6mm The gap out the box is about 0.8 - 0.9mm If it still fouls ,you have an ignition problem Porting and compression affect the gap you can run

What gap are you running?

Are you gapping your plugs to .024?

Thanks for all the suggestions, you got my creative juices going. Machine up Alu bushes, pin to pole(I initially loctited them but that didn't last). You can then use a normal SS bolt with two nuts to lock up. Use highest grade loctite but doesn't need activator(so you can get your pole off...

Has anybody run an oem 760 impeller in an oem 155 pump in a freestyle ski. Does it work or is an AM impeller necessary?

Haven't seen that before

Skim step off head, fit 48mm carbs, Hooker impeller and scoopgrate are all you need. 150hp, a few more tweaks and you can have 160hp.

Move back. Use what was the rear threads as the front threads for the engine mounts

You can, then drill hole from the side. Novi used to do that

Not sure which year they came on

FW keys will only shear if bolt is loose or the taper of the FW and crankshaft don't match

Jhb I take you are in CT? When you run a 1200 for FW you need as clean as possible carburetion, took a while to figure it out

I think ProTec

yes