Search results

Im a tig welder also, I own a fabrication shop and picked up a prototrak mill and a lathe a while ago and have nobody to teach me. I usually get way over my head with stuff, and I was already questioning the rigidity of clamping it like that. Like I said, I'll send a pic of the inside of the...

I'll send a pic of the damage tomorrow, the problem is the bearings have tight tolerances and the pin wouldn't go thru. I'll try grinding and polishing tomorrow then. I tend to go way overboard with things.:(

I recently licoriceed up my 2012 KTM swingarm while doing a bearing replacement. Stupid me was using my ironworker to press out the old bearings, the punch went off of center and scraped the wall of the bearing surface. I have an idea to fix it, I want to bore the surface out, polish it and then...

Excellent seller, replies very fast and kept me well informed. Would buy again! Sent from my iPhone using Tapatalk

Sure, what thread, length and caliber?

I'm one year away from buying a handgun :( But I have 2 ARs, a blackout and a 223, a 7mm mag and a 308 Rem 700. I hand load for all of them. For the blackout I use old 142gr tracers that don't light anymore, got them super cheap. For the 7mm I use the nosler 150gr BT or Hornady SP 175gr...

If y'all need any machining or aluminum TIG welding for it, I'm just a short drive over in Delavan wi.

I picked my 2012 ktm 250sx up last year for 4700, and sold my 2012 150sx a couple months before that for 4900 and the prices have probably gone down. The thing with the Yamaha two strokes is that you're paying 7500 for 2006 technology, but ktm refines their bikes every year. Also the powerband...

Yamaha and ktm make brand new 2 strokes still. And trust me the ktm is much better than the 2 strokes were back in the day. Sent from my iPhone using Tapatalk

stock 701 ada head and factory b pipe paired up with a skat mag pump, hooker prop ( cant remember the pitch) with trim

it doesnt ride nose high at all unless your are going very slow. it feels very light and it can turn on a dime.ive only ridden two different aftermarket hulls so my opinion may not be the best. I havent landed a backflip yet but i was pretty close to nosing one in off a small boat wake.

i have one and its actually a really fun hull. i have a q8 and an amp,and i prefer the way the amp handles. once you get them dialed in they are not bad

Does anyone know the length for the driveshaft to be used with a setback mag pump on a superjet? Sent from my iPhone using Tapatalk

I'm getting a little bit of cavitation, but I'll be getting a hooker soon, the nynja chamber sounds nice, added a lot of power along with the hull swap, I haven't ridden a ski with a factory pipe chamber so I can't compare. Sounds nice though:) I'm probably gonna get flamed but I ran it with no...

I have a c4 chamber on my Kawi q8 and it rips hard, I haven't tried a factory pipe chamber though I pieced my exhaust together. The mount is not useable you will need to fab your own, don't try running without the mount either the chamber will slip off the header and will choke the engine.

Instead of buying a floaty just glue hydro turf on the case till it floats. Sent from my iPhone using Tapatalk

Wrench for b pipe manifold, I just ground down the sides of it to fit. I'm pretty sure everyone else does this. Sent from my iPhone using Tapatalk

I ordered some parts from them and there was a slight mixup , but was solved quickly and professionally. They sent me a free shirt too!

I'm running a c4 chamber in my q8.

Wow. That sxr looks like it rips.