Search results

does anyone know where i can get the shifty mod for my TL?

Is it ok to be running 215psi in a lamey 8mm stroker with pv. it's the cast cylinder with 7 ports.

Want to know where every is putting there batteries and how they are mount them down when they are running a Power Factor Pipe. Thanks in advance.

What is the best carb or carbs to go with on a 760 sj for freestyle?

Who is running on of the new solas 144mm pumps. is there a big difference over stock? How is it better than stock? Thanks Chase

whats the deal with the third middle jet in a carb.

Does any one know the difference between a sn pump assembly and a rn pump assembly.

Im running a 760cc motor in my superjet just rebuilt it and put 33cc domes in my ada head im only getting 150psi out of it any one have any clues or direct me in the right way. Thanks

what would be the best for freestyle a single carb or dual 38mm. and what cylinder would be the best? what pistons flat tops or dome? Im only asking cause i just blew my motor up. the crank went out so im starting over. Thanks Chase

Does anyone know where i can get a 48mm blackjack carb?

What screws do i need to turn and how much on my factory b pipe for the most low end out of my ski? Thanks

Does any one have step by step instructions to take the rev limiter out of a stock cdi.

i have a 701 ada head 33cc domes, factory b pipe w/mod chamber, single 46mm carb, and freestyle ported. i had it in a sn and now put it in a rn they have bigger exhaust tubes and changed from boyseen fiberglass reeds to v-force reeds. what do you guys think.

I have no clue where to start turfing my superjet, it has footholds dont have a clue how to cut it or any thing i would also like to do the rails and bumpers is one sheet of turf enough and any help would be great. Thanks for your in put.

does any one know what size and kind of rivets that you use for the exhaust exit on a rn superjet thanks for the info.

Ive been working on this hull for the past few months the nose was busted off and the bottom was kind of repaired. It is all looking good now. It has wamiltons foot hold, Blowsion one way valve, I put a 24/7 sr22 hood and nose piece. Plans on the motor is 62t61x freestyle ported, Single carb...

where do you get the big thick handle pole bump pad?

can any one tell me where the location of the trim tube goes any help will be appreciated.

im trying to figure out what chamber i have for my b pipe can some one tell me? thanks

Hi im new to freestyle i ride flat water and was wanting to know where to start for doing barrel rolls can any one help me. Thanks