Search results

I have a older cast PV cylinder that has the sea doo PV caps and am needing some advice on where to best set them for freestyle any help would be greatly appreciated.

Selling a jetnetics aluminum flywheel for a yamaha 61x stator. I was running this on a 760 motor and It hit hard. The only down fall to this is that it had rubbed on the inside. It doesn't affect it at all. The key way is in perfect shape. And was pulled off a running motor. Selling due to...

Does any one know if the ATP waterbox will flow enough for a 1100 triple?

I currently am running 46mm full spectrums would it be worth it going to 48mm's

I know I have three sets of domes not sure what they are to. If someone can help that would be great. They are Ada domes and here are the markings on them. Yak8527L18, yak85525, and kd1224 any help is appreciated.

I need some one who knows all about these motors. I have some questions about them. Please pm me thanks chase.

So here's the story I bought a clean stock 07 sxr and had little to no time on so I took it and made it into a limited setup race ski. My first ride on it was ok but when I was doing wide open throttle runs it was acting funny I could go the length of the pond one way just fine but when I was...

I'm running a dasa 800cc PV motor with total loss and pfp. I'm running a solas 144mm mag pump what would be the best prop to run. Thanks Chase

Ok building my wife a new ski and am wondering which pipe I should put on her 96 superjet I have a riva free ride pipe or a factory type 9 which one will creat more power?

Should I port match the manifold to my cylinders or should I just run it? It is all ready installed too.

All the sudden in my bob i started to have a rattling noise coming from my pump area I did have to pull the back two bolts out of the pump that's mounts it to the hull. It didn't have any shims to begin with. It was fine before I did this what could have changed. Now it sounds like a sea doo...

Hey guys what do you think of my 2nd turf job?

I have a PV lamey motor that is a 8mm stroker in it running 215psi compression now what's the best way to go about adjusting the PV's. I'm new to them so I need all the know how thanks chase

I ride a bob and have a 8mm stocker motor with PV and ride just freestyle and am wondering what is the best pipe to go with.

I'm running a 8mm lamely motor with PVC and putting a riva free ride pipe on it I'm going to put a flow control valve on it should I still run a main jet restrictor as well?

i have a limited race ski and a set of 46mm riva red tops and a set of 44mm blackjack. which would be better to run? Thanks i also have a pair of 46mm buck shots

Whats the best way for routing and running a dry pipe. i'm going to run it dual cooling so i have that covered. i'm looking for the way you rout the lines and how dry to get it and how to dry it out. I'm running one line to the manifold and one to the first fitting on the chamber and then from...

I have a 8mm lamey with pv's and what would be the best pipe to run on this motor? I have a factory b pipe and a riva dry pipe should i get the pfp? all i do with this ski is flat water freestyle if any one could help and point me in the right direction that would be great. thanks chase

whats the props that every one is running in a limited race ski

i'm building a sxr for racing the limited class what do i need to do to make it handle right around the corse? what i'm looking for is like ride plate, intake grate, and sponsons ect ect.