Search results

Gents, I am looking to buy a worx intake grate and stock steering nozzle for a Polaris/Solas 140 reduction nozzle. Please PM me.

My 2002 Polaris Octane re-do, I bought the ski a 3 years ago and for the last year and a half she has been cut up and under the knife. I started tearing the ski down October of last year and its been a long story ever since..I bought it and rode it a few times but after riding a few other...

Adjustable how.? They have ones that you can physically stack/add spacers between the cone and the pump housing? -Side note WetWolf makes the " Adjust-a-thrust" which has the white nylon sleeve that automatically adjusts-extends/retracts while under load when riding.. I have no review for this...

I have 2. One on a solas mag pump and the other on a 140mm Kawi Pump. On My Kawi 140mm, I can say that improvement was very minior on my application, Infact really no feel or seat of the pants factor at all. *But, Used In conjuction with a properly set up pump ( assuming a stock kawi pump...

Looking to replace my torn impellar seal on the front of the "stock" prop that goes over the D shaft. I have tried a few searches. These are SOLAS based Props right? My local Polaris Place doesnt like to deal with the former PWC products. anyone chime in on this? Thanks -JW

I know most engine builders say to run a seperate pulse and fuel line for each individual carb on most engines. However has anyone Run the Pentagon High Volume Mikuni Fuel Pump to fuel their dual MIKUNIS? seeing how the stock carbs piggy backed the pulse and main feed from each other and the...

More importanly , Are the stock hoods filled with any floation material? I know that the have a pretty lack luster attachment to the hull and can easily come off. My hood insert inside the hood shell is starting to seperate at the bonded joints and the green glue is is flaking off. I didnt know...

-I am in the process of De-foaming whats left in my Octane hull, I know these Wammer/Polaris Hulls leak in water like Swiss cheese. However, I am going to need to put something back into the Hull Tray. It is going to be damn near impossible to seal up all the leaks, Knowing water will make its...

Hey guys after rebuilding my carbs over the winter, I took the octane out for a few rides. I got the watcon jetting setup installed. ( i think, please chime in with positive advice) i put in the 75 low jets and the 138 high jets. and replaced all the gaskets and viton needle. the seats were...

Anyone running the Jet dynamics plate and grate? I was not aware they made one and I am trying to decide if I should go with the WORX setup or for the Jet Dynamics, My octane is still running the stock Sh**y Setup. Please Chime in. also interested in used stuff, Thanks

Hey Guys, Have been reading over and over on here as well as other sources. I have a 02' octane and the mounts finally dettached from the green bonding glue. It appears that the previous owner had the pipe side mount reglassed with a single layer of woven glass. however it has pulled about 90%...