Search results

Oh Cool!....they're making more FX-1 handlepoles for 2010 ;)

Nice!....WaveHog and Joe B representin' Surf looked killer!! Looked a little bigger but less clean in Brig.

Nice!! Good to see some FXs doing what they do best

Cool pics!

Super strong south wind today chopping the crap outta the waves here in Jerzy...still fun though! The swell is incredible and if the wind ever lays down it's going to be epic.

Steering cable won't work

Lookin' good for Jerzy!!! :bananajump:

Check out this thread: http://www.x-h2o.com/threads/13853&highlight=jetskiff This was something I built a while ago.

definitely check your grounds....I'd start by using a ground jumper from your battery to the engine case to eliminate the possibility of the main ground cable being bad. Lot's get burnt/melted by the pipe and then corrode. It's a real quick easy thing to check if you have a jumper cable.

Kirv, We pretty much hit these rides every weekend at high tide. If you want to join in, hit me up with a PM. For times/tides, go to: http://www.saltwatertides.com/dynamic.dir/newjerseysites.html and select Absecon Channel, State Route 87 Bridge. The time in that chart is pretty much what...

I hated the way the Blowsion spring lifted the pole. I've heated them with some success but they usually break in short order. I've also had some success with strapping the pole down while stored and the spring eventually relaxes a bit. My final solution for both of my skis was to toss the...

epoxied/rivot'd ends, built up pole with biax to match level of aluminum ends, another layer of biax over the ends, then layer of carbon/kevlar to finish it off. Can't tell from pics, but also made a fiberglass plug of the inside of the top of the pole (aluminum piece) and bonded it into the...

Nice surf action......Where is that riding spot compared to where Wavedaze is held? It looked like an undeveloped area.

Well intentioned advice, but not correct....the FX has different ride plate mounting than Superjet. You could accomplish the same thing on an FX by simply drilling a hole at the rear of each main chine but unless you fix how the water got in there in the first place, it's a very temporary fix.

Right on Brutha!

check out boats.net ($123.09)

:lmao:

Fp

OEM seals are still available for about 120 bux.

Couple pics showing factory hood seal......