Search results

I am doing a leak down test on my kawai 550 ('84 piston port) How many lbs should I put in and how long should it hold it? I have gone up to 12 psi thus far, and it loses the first 2 lbs in about 2 minutes, it hits zero after about 20 minutes. At what point should I be looking for leaks/will the...

how about the stock standard one, can that be had somewhere?

it is just one big spring, connected at the top on either side. the lower left leg is what broke, look close. All I know is it was completely neutral and kept the pole up on its own, so I want another one of what it is.

looks similar.... so do you recognize whatever spring that is? you can see it is broke off on the left side.

see photo. there is a hardline products sticker on it... perhaps someone just put it there? I have seen that handlepole on other people's skis on this forum, so i know its not too foreign.

I have a hardline handlepole and broke the pole spring that holds it up this weekend. Anyone know if the pole spring on there was hardline specific product, or is likely it was aftermarket? Whatever kind it was it was really nice because it kept the handlepole up (zero weight). Does hardline...

it has other mix ratios on the bottles..... i dont understand how I can tinker with mix ratios that much? I usually go at about 40:1 just to be safe, but to go from 40:1 to 60:1 ? Is the oil that much better and how do you know if you are getting adequate protection when running leaner?

have a contact that got me amsoil at his cost.... a lack of communication landed me with 2 cases of saber outboard instead of the dominator. Still good or should I try to swap it out?

zero - aware of that.... As I see things, you cannot dry out exhaust with single cooling line, or you'll toast the engine. $300 from where ?

the goal was to be able to dry the exhaust out... not worth it with stock compression?

think I dare do it with the head installed? Don't have a head gasket handy either...

already committed at this point, I tapped my pump and manifold... was going to go with girdled head and then a flow control valve to regulate chamber temp, but don't really feel like spending the dollars at the moment, didn't realize a head was close to 400 bills... If I do a head I might as...

Running a stock head whats my best way of rigging the cooling? I want two feeds going into my manifold, for the added safety/redundancy. Obviously the goal is controlling the pipe temp... So the question is, what do I do with the lines after the manifold?

flight risk are you talking polyester or epoxy?

filler for foothold install.

Can I use micro balloons in epoxy? I see they make all these goofy filler additives, but aren't they essentially the same as mixing micro balloons in?

here

https://www.wamiltons.com/pdfs/sccuper.pdf found 'em. looks like you wouldn't want to add something after the fact.

any idea where? i looked around a bit and couldn't find it.