Search results

well crap! ARGH! at least its still torn apart... but the directions defiantly said that its not nessicary... and the stock ones didn't have any loctite, on the read screws or cage screws... I assume just use blue loctite?

I need a special tool for pressure check right?? I never done one, how do you do it?

I didn't use loctite... The directions said not too, and the stock ones didn't have any loc tite on them? Should I re do it???

ok, Got my carbon tech reeds in, after I get everything buttoned back up, I should run a compression check right? How will I know if I dont have any leaks?

None of my retarded friends will go with me! :aargh4: How many guys are actually staying in the camp ground, maybe I'll come up by myself.

ahh... I'd rather not take the cylender off!! if it comes to that I guess I have too, but I will try the extensions first I suppose.. I thought this would go together much easier! Also Whats a bottom tap... I think my set is might not be bottoms?? Anyone got a picture of what it looks like...

I have a Huge Tap and Die set, so thats not a problem. MY question is what did you use to thread the tap in? Theres not much room, since my tap set uses a T handle to thread.. that wont fit on the tap that close to the motor.

Anyone know the tap size to use?? whats a thread chaser?

motor is in. Everything is torn down, I'm reasembling now, starting with ada head.. so pipe, and carbs are not in the ski.

not really, what the best way to do that? theres not much you can get down in there??

ya I have those! They aren't real helpful!

pm sent Thanks MAN!

ok, so I started to put my ada head kit on and ran into trouble. The girdled studs, obviously one side has longer threads then the other. I assume the longer treads, go into the block?? I did the middle two first they went all the way in no problems. Then I moved on to the side, and man I cant...

ok, I was putting in my high speed jets and those 2 screws that hold the valve body down, well of course one stripped out so I had to drill it out and use an extractor. Well now I need a new screw. Wheres the best quickest place to get the screw from mikuni direct?

I"m gonna see if local bike store has one I can try.

ok, sounds like I should order the medium

That boat has the same set up motor wise that like 90% of the people on this board run. B pipe, ada head, enhancer, reeds, prop, grate.

holly X4 roll batman! :bigok:

ah ok, So then I would need the full system! I need to save my pennies, want a trim sooo bad :crying:

I just got a limited set up, I"m putting together now. Also got all my stuff from art. He told me to run the 13/17 as well, I believe Wammer recommends the same prop. I would give that a try! I hope to have mine all together by this weekend.