Search results

Assuming the Impeller Edges are in good condition, Pump-to-Impeller "daylight" Clearance is less than 0.6 mm, the Pump Seal is good and the Stator Vanes are not chipped, jagged or broken, then it is likely that you have a Lightweight Flywheel along with those other Bolt-on Mods you listed. The...

Mister Ho does no such thing! :cool:

I dunno....a 64 year old feller Racer just ordered the Fast Powersports F1...He's been riding a 70 mph Kommander GP1 for the last couple of years and he still tears up the buoy course like he's the Ghost Rider on a night ride. This Guy is a Legend 'round these parts. An Elite Rider that will...

Statistically, your luck is about to run out after 20 years... Seen meltdowns and one fire, on other random People's skis. This usually happens when the Bilge Pump Impeller gets stuck/locked-up with debris, then the Bilge Electric Motor overheats, wires melt, and sometimes it catches on fire...

Remove the Long Studs first. In the Real World, these studs are not perfectly straight and centered in the Cylinder Block Holes, so they can/will put the Block in a bind...

Since the Engine severely overheated, the Aluminum Components such as the Cylinder Head and Crankcases may have warped. When it's running cold on the Trailer, the Mating Surfaces will be air-tight. As soon as it warms up, the gaps open up. and it loses Primary and Secondary Compression. The...

SuperJet Chop Shop...:(

Used to hang Jetski Thieves back in the day...;)

Donor Skis :p Guess they just wanted the Trailer?? o_O

A half full jug of Oil contains Air, which occupies half of the jug. Air contains Moisture. Cold temps condensed the Moisture into Liquid Water. Water mixed with the Oil... And, if it contained Castor Oil, realize that Castor Oil is a Vegetable Oil. Vegetable Oils go rancid, i.e. undergo...

This is like watching Paint dry...o_O Nice work.

Nice. Which one of the Superjets is the fastestest?

Flux Capacitor...

Is the Tray water-logged? :p

Hooray! :D

So you didn't ground the Spark Plug Wires? The 30 thousand volts have to go somewhere! That means that the Coils and CDI couldn't shoot their loads and got very hot. The Ignition Coils probably survived, but the CDI internal Diodes (electrical check valves) probably got fried. The CDI internal...

For 4-stroke Engines, a polished surface with minimum roughness improves flow and horsepower. And it works because the Exhaust Gases only flow ONE way. But with the 2-stroke Exhaust, some of the un-burnt Fuel-Oil Mixture and Exhaust dwells in the Manifold and Head Pipe and then goes back into...

@john zigler How much does shipping actually cost for a Handle Pole? How about for an Exhaust System?

Fake? Mister Ho had them two Engines rockin' and revin' side by side on the table. I was wondering when one of them PTO Couplers was going to bite him o_O And what about his Flambe Motor Mount build where he lights up that Rubber Glue and then presses the new Mounts on the Vise? Bam! New Motor...

Mister Ho is a Wizard! :D How can he make these Crusty Engines live again with the same used Parts? I too have WD-40, Pressure Washer, Air Compressor, Impact Wrench and a Hammer o_O