Search results

Yes that is exactly what I’m talking about, thanks for the pics! Still trying to get this dang fuel system primed. Could the fuel selector knob be bad? I did not swap that out as the hull has the stock one. It looks like I’m getting fuel in one line, primer is pumping fuel, but the return line...

Hey you still have the bpipe?

I am not using that round plastic fuel water separator thingy that the check valve was hooked up to, kept priming for a few mins and finally got fuel. I also only had about a gallon of fresh fuel because I probably will not ride for awhile, so that’s most likely not helping. I will blow into the...

Good call

Just swapped stock 701 that ran perfectly before I put it in another hull. I doubt I have any air leaks, marked all my fuel lines so I know those are good. Motor has been sitting on bench and I have a Home Depot 2” plug as the nose of my ski is covered and can only fill tank internally. I need...

Jetmaniac is not for sale

No...stock SN box.

$40

It’s a SN so it has a fiberglass SN box, I upgraded to jetmaniac box I don’t know if you saw that in the photo

My midshaft slides on and all 3 holes line up perfect without forcing it in any direction. Like I said before, when I took the ski apart and took the 92 midshaft off, it was centered but vertically the driveshaft was hanging really low, it was almost touching the thru hull hole on the bottom. I...

What do those run for?

Great video thank you...

The picture is deceiving, it looks damn near dead nuts center of hole when looking at it. I can see the angle of the photo is to the side a bit. I want I slid the midshaft in and it aligned up and spun freely, do not have motor in yet. I want to do this right, I guess I should get the alignment...

Hey can you send me photos of what you have? What chamber?

Just wanted your guys opinion on how my driveshaft alignment is looking (if you can even tell in the photos). I installed a worx aluminum pump shoe that fit nice and flat, and used 5200 to seal my gaps. Had to add quite a bit of shimmage to the rear of the pump, as I am swapping everything...

Thanks for the input, I believe it is good.

Long story short I’m swapping everything from my 92 SN stock ski to a freestyle built reinforced 95 hull. I got a new midshaft housing from Jetmaniac fully built because I needed the bigger housing. I got my buddy who owns a auto repair shop to press my old midshaft into my new housing on his...

Here is the hood I’m on the ski. Had original handlepole rubber pad