Search results

I was wondering if I could get some insight on what hull would fit my needs. I plan to shred the lake 95% of the time. The other 5% would be in surf like conditions. I want something that I could flip off a boat wake and carve if I wanted to. Preferably light and strong, under 100 pounds?? Was...

1450 shipped buy pays fees. Middle and bottom screw are stuck closed top moves freely(set up for bottom end) includes manifold, head pipe, chamber, rubber couplers, turn around pipe.

$1800 Yamaha drop in package. Riva flame arrestors, zeeltronic total loss, ada head, 20 hours on top end refresh, 62t/61x dual 38s. Tuned for a b pipe. Buyer pays shipping and fees located outside Dayton oh. Long block + electronic no pipe

Hull only 1800 Includes pump, skat 12/17 c75 impeller, riva extended ride plate, scoop grate, factory water box, steering, dual cooling, just drop in motor, pipe, electronics and go. Read Less

Stock is fine forgot the loctite:rolleyes:

Anybody get the new 1200cc krash foot rocket yet? Any reviews thinking about buying one for next year. Didn’t even know they put a bigger motor in this year.

High roller stunt freestyle ski. Rode it a couple of times and realized it wasn’t for me. 62t dual 38s, pfp lay down pipe, go kart gas tank, dual cooling, wamilitons steering, am light weight pole can’t remember who made it, wamiliton finger throttle, rickter trim lever, 144 blowsion trim, 86mm...

.

Got a ported 62t 150psi in each hole 70 low 135 high 55 psi pop off stock fa. I’m in the water it planes out and it feels like it doesn’t have any grunt until right before wot. Plugs look black and rich. Any thoughts or ideas?

Make me a good offer will need repaired. Or use as parts

Ended up having a chip in the cylinder. So went a different route. Trying to recoup some of my money. Opened the box but everything is there. Asking 150+ shipping. Buyer is responsible for fees.

Chasing an air leak plugged the exhaust and used a pop off gauge/tool to pressurize the crankcase. I can hear and feel air passing through the reeds. I made sure the intake and reed cages were sealed with a little yamabond. Is it time to replace the reeds?

Hey I was wondering if anyone has ran a in line resonator with a pfp lay down pipe. The water box will not fit without being modified. The resonator has a water fitting as well. Don’t want it to be ear piercing loud.

Need a good place to start for jetting this thing. Pfp pipe, 195psi comp, 718cc, ported cylinder, ported case, ported intake, port matched gaskets, dual 38s, stock flame arrestor, zeel total loss.

Looking to buy porting templates

When installing the cable. What’s the best way to install it through the hull? Is there a fitting I can get similar to the water fittings to make it water tight? Would like some advice before the job. Don’t really want to drill a hole and slap on some silicone lol.

Looking for a 144/148 trim set up.

Wanted: Power Factor Pipe + water box

All screws must spin