Search results

ttt

ttt

bump

ttt

ttt

ttt

ttt

ttt

It was going on a xs900 with 46s but will work on any 62t cases

They epoxy the inside the intake runners to reduce volume

Brand new boyesen intake with exscream mod includes rad valves gasket speed plate and hardware 550 shipped us only sold

Brand new complete power factor pipe 1350 shipped us only sold

Once you take that plate off the front carb to put on fuel pump you have no fuel lines for in and out

after further research i found out it is for 650 the early 6m6 650 it bolts right to the stock manifold which is the wave runner 650 lx, it wont bolt to the 6r7 650 manifold which is the later 650 vxr wave3 thanks for the replies

does any one know what this pipe is for im thinking its for a wave runner 500/wave jammer the 4 bolt flange does not line up with oem 650/701 manifold can any one confirm this thanks

looking for a solution my hood liner is all cracked up i have 4 breather tubes but i think that the two inlet holes are to small has anyone enlarged them and what was the results cause looks as it will take in more water once opened up i didnt have this problem with smaller motor so i think...

i do run them in my ski along with case stuffer and they work great and i have built 3 other motors with the same set up and they all ran good

well you should tell yamaha their wasting money cause my yz250 comes with reed stuffers stock and iam sure they dont buy them from r&d

yeah it had me thinking i have a superfreak which is rockered and they are hard to stab and sub and i think doing rocker to a rn is prolly going to make it the same so i will prolly just leave it alone i aiready shorten it 4 inches in the rear

no one has this ?