Search results

144 trim kit. Has rubber ears on stock nozzles. Cable, cable holder, and blowsion lever. Bolts right up. Was ran on a SJ but could run on anything with 144 pump. Will not part out. $270 shipped in 48

Looking for dual 38s for superjet/waveraider/wave venture. Must be duals and not two individuals that I have to assemble together

Looking to buy a 155 impeller. Cut back preferred but not required. 7/13 or 7/14 preferred but closely related impellers also welcomed even if 8/13 possibly

Looking to see if any used black dual tube pole brackets out there. Thanks

Looking for a few parts before buying new from dealer: stubby pump cone for 155 OEM pump straight pull trim cable for xs or rrp trim style trim systems couch mounts or OEM SJ mounts Xmetal comp pole kit. Black. (comp pole, chinpad, mounting bracket, pinch bolts) AM battery tray. Aluminum...

Looking for a new and never used pump shoe that someone ordered and not going to use before purchasing from dealer

looking for a black thrust throttle lever. Single finger. looking here before purchasing new from Thrust

want to buy kart tank or similar 2ish gallon. I would consider a Jazz with a good working cap or aftermarket

Looking for thrust steering system, black preferred. Also looking for RRP fatbars. And pre08 superjet cable.

looking for a 148 pump. fresh water pump preferred. Good bearings and driveshaft with reduction nozzle if possible. Otherwise willing to purchase in parts as well

As title says. Looking for working 61x 701 stock cdi

Dasa head shell. Came off motor bored .050 with a 4mil stroke. Current domes are 34cc. Can replace or run the pitted dome to run 4 mil or purchase standard domes and run Stock Stroke crank from my understanding. Comes with studs for cylinder and hardware seen in picture. $190

Droptrim nozzles that came off my sxr800. It was used as a droptrim. I'm sure it can be used for an uptilt trim by reversing the nozzles but I have not done that. Not a stock reduction nozzle from what I remember. Steering nozzle is extended and has an 85mm bore. No cable. But I have a lever...

f

I briefly discussed this once prior. Who all here has installed an ATP steering system to the xmetal adjustable pole? Did you have to drill out the chinpad in order to set it down a bit further to clear? Any adjustments needed to be made to the Xmetal pole system? any thoughts?

Looks to be an early walmitons lowered hood? Anyways I am parting out a ski and here is an extra hood for the ski. Carbon fiber finish on the inside. The epoxy us stsis rting to split on the side seams. I havent fixed that as i havent had the time or interest to take care of it before finishing...

please delete

Seems I tend to break steering cables with my 1105 but not my 900. I have gone through a few. One or two was completely my fault, the other one was partially my fault and partly wear. This last one busted on the threads on the pump end mid roll and threw me and the ski flying. I don't want to go...

Needing help on a Polaris couch. Figured it was slim pickings over here and thought to go to PWCtoday but can't post on there and haven't figured out how to fix that so getting irritated and still looking for help. Any polaris people on here or anybody that can help. Looking to diagnosis...

Let me start by going back a few years. In 2014 I started off on a Bob gen2 and a JM781, I can say great things about that motor...not the hull however. While selling the parts of this build I finally went to Havasu thanks to a local buddy of mine (@Todd grochowski) who we both experienced our...