Recent content by Heelz23

Thanks man, I'll do that. Glad the pic finally posted, have you ever seen a filter do that before?

Thanks man, I dont understand the pics, I can see them on the posts, crazy that others cannot. Anyway, mine came apart right where the seam is at black part is on this one. I smelled a stronger gas smell the other day as well so I am guessing it was leaking gas and not holding pressure. I...

Is it showing up now? Cool, so you use that filter in addition to the oem filter? I am not sure where I got that one from a few years ago but I see this one on amazon, it a little cheaper than the Yamaha one...

Tested the plugs and got 4.16 so I am guessing the coil is good. I then pulled the tank valve and its good, nothing in the water separator, then pulled the lines in the tank, they looked good so I went to take the gas filter off to get a better look and when I took it off the rubber hanger I...

Thank You. Will start there. I was thinking the gas filter but when I looked at it, it looked fine, could not see water or trash in it.

I have a 701 Raider thats been running great, however today it started hesitating from 1/2 to full throttle and would not get up to speed. If I sat and let it idle, it would run fine for about 50 yards then start to hesitate/bog again from 1/2 throttle up. Ran fine from idle to 1/2 throttle...

Thanks man....can you tell me how it works? I am guessing its discharging out the back?

on a 97 Raider. Small white box sitting where a bilge would normally go. Thanks

Thank You!!!

Just bought ski and thinking these are still good, just the outside covering cracked but wanted to check with the experts? Good or not? Thanks

Hey, I have a pressure washer, had not thought about that....powder coat wont last...is painting better or just leaving bare aluminum?

Like the blasters but think my little 1.5 HP compressor would disappoint me....

Thanks, I have a small 2 gal husky compressor with max 100psi....not sure that would work??

Thanks, but I dont have a media blaster...anyone know where a good, small hand held is at? Anyone have an idea how much a shop would charge to sandblast then powder coat it?