Recent content by Dorny119

Years ago i towed a friend's squarenose (and him) a little over a half mile on the Connecticut River with the current working against us with my Tigercraft Aquabot V1... The rope was tied to the left side of my handlebars. It was awful. In retrospect i could have tied it around the pump maybe...

I hope that's your fix! What i have noticed is that even a good MSD Enhancer will cause a light switch affect on some of my setups. It's actually really annoying when i am trying to make a setup wake at low speed and i can't find the happy medium. Depends on the over-all setup.

I PMed you about domes. Thanks!

when you say the WCOT lowers your top speed to 57mph; what is that relative to? what was your top with the other grates?

I have a modified 65V nozzle that i milled to accept my Xscream OG trim. I put it on my M1 as an experiment. It definitely felt more playful. It was like a little more "loose". Yes it added a bit of static trim as well. I removed it because i felt like it was easier to chase boats with my 62T...

SOLD

2002 Yamaha Superjet $6,000 I have owned this ski for 8 years and have built it over that time. I love this ski but it's time to move on. - Jetmaniac ported and epoxied 735cc - Mototassinari VF3 Reeds - ADA Head 35cc Domes (pump gas) - Factory B pipe (Limited) (screws turn) - Dual cooling -...

2002 Yamaha Superjet $6,000 I have owned this ski for 8 years, and have built it over that time. I love this ski but it's time to move on. - Jetmaniac ported and epoxied 735cc - Mototassinari VF3 Reeds - ADA Head 35cc Domes (pump gas) - Factory B pipe (Limited) (screws turn) - Dual cooling -...

oh dang! I should have guessed. That happened to me last season with my Protec Mach II... Glad you found it! I don't blame you for wanting to ride over wrench. I am thinking about buying a TR1 SJ for just that reason.

Check the internal fuel filter and all the jets for cloggs. it's not the temp sensor, and if it's bogging then eventually "flames out" (shuts off?) then i would not think it is electrical. This sounds fuel related.

I had to use a ratchet strap to pull the bolt into alignment with the hole because the spring was trying to hard to put the bolt towards the nose of the ski. I would tap the bolt with a mallet, check alignment, ratchet the bolt into position (or release it, depending on alignment) and repeat...

Honing Bench My home made honing bench uses a harbor freight parts washer tub (every other part besides the tub itself is trashed). I plumbed in a shut off valve to the bottom, using 3/8 lines into an oil filter. The motor is from amazon, and is meant for fuel transfers (it's a gear pump). I...

Yes idk what the calculation is for that. So i assumed an extra 5%.

Here are my notes from today's notebook. The ski only has Pole breathers. Is that enough? When i rev the ski (yes on dry land), the hood does suck down into the seals aggressively. This means there is vacuum inside the bay. I don't know how much, but right now i know that i don't want it. Lets...