looking to find someone that can port and bore my 760 62t set up. its a 64x motor. i have new pistons (85mm), so it needs to be bored out and i would like some more bottom end. so i guess im looking for a freestyle/freeride port if there is such a thing. whos good at doing this without spending a butt load?
62t 760 cylinder boreing
- Thread starter go4it743
- Start date
superjetkev
x-h2o
- Location
- downriver, ontario CANADA
i sent my stuff to jetworks. It didnt cost a buttload, but you need to define buttload. 200 bucks? 400?? GOOD porting isnt easy or everyone would be doing it.
SUPERTUNE
Race Gas Rules
- Location
- Clearwater Fl.
Our shop rate is $75 per hole for std .5mm over bore. If you are at STD 84mm bore now you would incur a extra boring pass of $4 each hole to over bore from 84mm up to 85mm.
You really can't lower port timing unless you machine the bottom of the cylinder to get great hit off the bottom.
The 760 64X cylinder can be a little flat off the bottom without a real aggressive engine setup.
You really can't lower port timing unless you machine the bottom of the cylinder to get great hit off the bottom.
The 760 64X cylinder can be a little flat off the bottom without a real aggressive engine setup.
SUPERTUNE
Race Gas Rules
- Location
- Clearwater Fl.
I tried a few different amounts off the bottom, I'm thinking about .055 then do the porting.
- Location
- Jacksonville, Florida
LPW porting
Paul@ LPW/ jr magoos did my friends port job and the thing is tops. He just completed mine and I am looking forward to his work. He's super cool to deal with!! Give him a call...
I have heard great things about Supertune's shop as well
Paul@ LPW/ jr magoos did my friends port job and the thing is tops. He just completed mine and I am looking forward to his work. He's super cool to deal with!! Give him a call...
I have heard great things about Supertune's shop as well