waxhead
wannabe backflipper
- Location
- gold coast
Here is a drawing i have been working on
i have yet to finish and to add the pv,s
I am hoping to get copy of tsr so i need to run the port time areas yet but its close
It needs another 20 or so hours to finish
I have the use of a 3d printer and i will get it printed out and see how it works out
Will end up with a plastic cylinder useless but i can at least check design
i have yet to finish and to add the pv,s
I am hoping to get copy of tsr so i need to run the port time areas yet but its close
It needs another 20 or so hours to finish
I have the use of a 3d printer and i will get it printed out and see how it works out
Will end up with a plastic cylinder useless but i can at least check design
Attachments
Last edited: