This is what happens when I let Newbies ride my Superjet...

wavegoddess

pimpin' aint ez...
Location
Austin Texas
I have only had her for a month, and now she's in the shop....

100_0934.jpg


This was lodged in the casing when the guy took it apart...
100_0935.jpg


100_0940.jpg


100_0939.jpg


Not as bad as it could be...
100_0943.jpg
 

wavegoddess

pimpin' aint ez...
Location
Austin Texas
damn.....so did the newb ingest water or something?

That's what we are thinking. I don't know enough about engines to jump to my own conclusions, but that's what the guy at the shop said.

My friend was in the middle of the lake, and he kept trying to start it over and over again. This is after falling down a million times. I had to wait for 10 minutes until I could get somebody to take me out there on another ski... I still need to get a bilge installed and I have a scupper valve, so it was taking in a lot of water also.
 

DAG

Yes, my balls tickled from that landing
Location
Charlotte, NC
yup, that looks familer, however i dident let the kid barrow it.. he desided to take it for a spin, break it, and bail... o_0
 
the one near sonic? When I used to live down in Bee Caves I would drive past that place all the time he would always have OLLLD skis out in the front. Besides I am free
 

wavegoddess

pimpin' aint ez...
Location
Austin Texas
the one near sonic? When I used to live down in Bee Caves I would drive past that place all the time he would always have OLLLD skis out in the front. Besides I am free


Yeah, I think Sonic is over there. It's a red building with a white 550 sticking out of the side. He seems pretty cool, used to race and do some surf riding. I have to go by there Friday or Monday to figure out what I am going to do. I will give you a shout then and let you know what's up. Thanks again
 

Prem1x

Tinkering obsessed
Location
Austin, TX
Austin Jet Ski knows what's up.

Or have Johnny do it. He'll even leave some bolts and clamps loose for free. :biggthumpup: :sneaky:
 
I can already tell ya you need a new sleeve then he has to port it to match the port job already done, new crank, either welded or new case pistons, ekkkk its lookin like some $$$$$$$$$$$$$$$$$$$$$$
 
Top Bottom