- Location
- Cloverdale ca
Can someone tell me what these wires are ?????
- Thread starter jpersons44
- Start date
Is the Ebox from a couch? They are probably for the gauge in the couch. Green is raw AC from the stator, probably used for a tachometer, pink is the overheat sensor (so there is probably an overheat light on the couch dash), red is 12 volt, black is ground, I don't recall what brown is.
If that is the case they can be removed, they probably even have plugs that allow you to unplug the extra wires without cutting the harness.
If that is the case they can be removed, they probably even have plugs that allow you to unplug the extra wires without cutting the harness.
Are the wires for the start stop switch separate from what you're holding in your hand? Usually the four wires going to the start stop switch are red, brown, black, white. Brown is the signal wire for the starter relay (the start button connects it to red 12 volt. White is the wire that gets grounded to kill the motor.
Sooo...if some of those are for the start stop switch you might have somewhat of a problem.
Sooo...if some of those are for the start stop switch you might have somewhat of a problem.
- Location
- Cloverdale ca
I'm thinking there from a couch that would make sense being that the start stop switch works fine I just saw those and was worried maybe I'll remove them in the off season.
Big Kahuna
Administrator
- Location
- Tuscaloosa, AL
Brown part of start switch normally
Ebox is from a couch. Extra wires are to go to the couch gauge. You will need to the black, white, red, and brown to go to start/stop switch.
Extra wires should be cut and capped inside the ebox.
Then pull them from the grommet and take some extra black wire to replace them, starting inside ebox through the grommet and loop back to the inside through another grommet hole. Cut off excess, leave about an inch of extra wire inside and this will plug the extra holes.
Not sure if that is for the gages or indicator lights, just what it says on my wiring digram.