Blaster yamaha 760

T

taylor2000

Location
Kansas
So i need to remove the flywheel. Im using the 3 bolt puller from Harbor frieght. Im assuming the threads are metric. Does anyome know the thread size and pitch. My ap and die set just isnt giving me the right answers. Seems like the standard is going but dont wanna goof up..
 
T

taylor2000

Location
Kansas
learned a trick today. its the same thread as the head bolts metric, not standard as the kit comes with. However mines on there tighter than a frogs but so im sending it off to be taken off properly. Thanks for the info
 
Freakrider

Freakrider

X247
Location
Tampa Bay area
taylor2000 said:
learned a trick today. its the same thread as the head bolts metric, not standard as the kit comes with. However mines on there tighter than a frogs but so im sending it off to be taken off properly. Thanks for the info
Click to expand...
Common problem is the puller binds on the end of crank...you must use a good washer between puller and crank, then it will come off easy...try that ok ?
 
Quinc

Quinc

Buy a Superjet
Location
California
taylor2000 said:
learned a trick today. its the same thread as the head bolts metric, not standard as the kit comes with. However mines on there tighter than a frogs but so im sending it off to be taken off properly. Thanks for the info
Click to expand...

That is normal. Get it nice and tight and then hit it with a hammer a few times. Tighten a little more and repeat. A little bit of heat will loosen her right up too.
 
kurtwolff

kurtwolff

Location
Mooresville, NC
Hit it with a 1/2" impact gun. I've taken off at least 100 Yamaha flywheels and never had one that wouldn't come off with an impact, hand sledge, and a bit of propane torch work :)


Sent from my iPhone using Tapatalk
 
You must log in or register to reply here.
Top Bottom