Super Jet Worx Dominator SJ rideplate question
- Thread starter duckman1
- Start date
Its bent, make it flat again.
Bent pretty good then, hate to weaken it and have the extension snap off..lol!
For 08 ? The 08 + Worx plate I got needed extensive grinding before it could be used . If it wasn't made in China then I don't know where .
Bolt holes had to be ground. They were off as much ad 3mm in various directions. Had to grind both edges of plate a lot just so it would fit into slot . One side more than the other. Then the plate was also twisted so that the right rear hung lower than left . After a lot of beating and grinding it is now is flush with hull surface front and back both sides .
Bolt holes had to be ground. They were off as much ad 3mm in various directions. Had to grind both edges of plate a lot just so it would fit into slot . One side more than the other. Then the plate was also twisted so that the right rear hung lower than left . After a lot of beating and grinding it is now is flush with hull surface front and back both sides .