Super Jet Which rivets?

[ErieOne]

After installing turf on a RN SJ, when reattaching the rear trim piece behind the tray, what size (length & diameter) rivets do I need? I'm sure I can figure it out but wasn't sure if there was a known spec someone could please share?

Thanks!!


Sent from my iPhone using Tapatalk

 

[SXIPro]

What year is it? All the ones I’ve done were held on with washers and nuts, not rivets. The trim had threaded studs on them.

 

[Big Kahuna]

Yeah, No rivits on the rear trim. Rivets were only used on the side rail trim.

 

[tomski]

The rear center trim piece is held on with rivets, then a cover slides into that.
The side trim uses screws, the rear corners use machine screws.

 

[ErieOne]

The rear center trim piece is held on with rivets, then a cover slides into that.
The side trim uses screws, the rear corners use machine screws.

Yes, exactly. It's all bolts, washers and nuts except for that rear center trim piece that slides into the molding channel. There are four rivets there. It's a 2016. Thanks!


Sent from my iPhone using Tapatalk

 

[ErieOne]

I ended up using 3/16" x 5/8" rivets & they worked well. Here's a pic showing where they are located on that back trim piece and another pic with the plastic insert slid back in.

Sent from my iPhone using Tapatalk