- Location
- California
Hey i got a 750 sxi and im gunna install my foot holds does anyone have any mesurements as to how far back to put them?
SX/SXi/SXi Pro where to install footholds
- Thread starter motorman021
- Start date
- Location
- Arnold MO.
my diggers came with instructions on where to mount them, I think it was about 2 inches from the back. Just make sure you have enough hull on the top rear edges to rivet them in tight
- Location
- California
ok wat did you do about your compartments did u remove the compartments completely or did you just glass over them right were they were at? do you need to epoxy them in place or can you just rivet them and glass em in?
Last edited:
- Location
- s florida
use epoxy glue or 5200 behind the holds, rivet's afterward and then glass over them
I always cut those out
- Location
- Arnold MO.
Yep, cut/chip the plastic caps off the back and cut out as much of the plastic tunnel you need to for room. I just rivited mine in without useing epoxy or sealant and glassed over them. I would use some if I did it again though. make sure you re foam behind the holds befor you cover the back holes up though.
- Location
- California
wen you mean cut/chip them out you mean on the very back of the ski kinda like just pull the tubes out the back? jus started on the install tonight and im having a hell of a time getting the tube out
tom21
havin fun
- Location
- clearwater FL
yeah its brutal. keep at it.
- Location
- Arnold MO.
chip/cut off the plastic finisher off the back. after you cut your hull for the holds cut out as much of the tubes as needed for the holds to fit in. they wont slide out the back, they are glued in very good.