SX/SXi/SXi Pro where can you buy a new Lord mount?

[sxipro02]

I'v been fighting with my exhaust alignment for a while now and think its due to the lord mount being too thick (1 3/8). I need one thats around 7/8"-1". any ideas before I just start bending the mount plate? This is on a FP MOD pipe btw.

 

[tom21]

jetworld or mcmaster

 

[fastony]

Here you go.
http://www.mcmaster.com/#isolation-mounts/=c4ojtq

 

[vitalikol]

I'v been fighting with my exhaust alignment for a while now and think its due to the lord mount being too thick (1 3/8). I need one thats around 7/8"-1". any ideas before I just start bending the mount plate? This is on a FP MOD pipe btw.

I don't think it's becouse of the lord mount. never had a alignment problem. What not align ? pics ?

 

[sxipro02]

I don't think it's becouse of the lord mount. never had a alignment problem. What not align ? pics ?

The issue is where the chamber meets the head pipe, there is about a 1" gap, it tweaks the chamber at a funny angle and over stresses the mount tab on the chamber. The tab has broken off twice, this time I welded a little extra support on it so it wont happen again. If I put in a thinner lord mount or bent the bracket on the cylinder it will let it sit better and the coupler will line up nice.

 

[Fenix169motox]

The issue is where the chamber meets the head pipe, there is about a 1" gap, it tweaks the chamber at a funny angle and over stresses the mount tab on the chamber. The tab has broken off twice, this time I welded a little extra support on it so it wont happen again. If I put in a thinner lord mount or bent the bracket on the cylinder it will let it sit better and the coupler will line up nice.

so which side of the throttle cable bracket are you mounting it on? i dont know how the actual one looks i had to make my own.

Would be nice to see some pics of your setup my fpp sits in there pretty nice. almost straight up from the throttle cable bracket bolts.

 

[sxipro02]

Mine is the mod pipe so the lord mount bracket replaces the throttle bracket, it's all one piece now. I just wound up bending the bracket back toward the motor a bit. It fits perfect now. I'll post a pic later tonight.